Wiring Harness - Rotax 912 i Series Installation Manual

5) Wiring harness

The wiring harness connects the engine control and the
General note
- Control unit (ECU)
- FUSE BOX assy.
- Cockpit (switch, instruments, maintenance connection)
- Engine (sensors, injectors, ignition coils)
The sensors are fitted by BRP-Powertrain and connected to the wiring
Sensors
harness. The exhaust gas temperature sensors are included according to
the version or already fitted on GENUINE-ROTAX exhaust systems.
The ECU/FUSE BOX connectors can only be installed in the relevant
ECU/FUSE BOX
connector
position. The connectors must be easy to install, excessive force is not
permissible and may damage the connector or component.
The HIC (Human Interface Connectors) connects the cockpit with the
HIC
engine.
Connector
Graphic
Fig. 10
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
INSTALLATION MANUAL
The wiring harness must not be shortened or modified.
NOTICE
WARNUNG
Part
1 FUSE BOX LANE A, LANE B
2 ECU connector A1, A2, B
3 Human Interface Connector A, B
4 FUSE BOX power supply
Function
24-00-00
January 01/2012
Page 17