Fitting The Faston Connector To The Harness Interface - Rotax 912 i Series Installation Manual

5.1) Fitting the Faston connector to the Harness Interface Connector
See
General note
NOTE:
The following special tools and equipment are necessary for fitting the
Special tools
Faston connector.
n.a.
n.a.
Fitting the Faston cnnector
Procedure
Step
1
2
3
4
5
NOTE:
Effectivity: 912 i Series
Edition 1/Rev. 2
BRP-Powertrain
INSTALLATION MANUAL
Fig. 10.
Faston connectors (1) are supplied loose. The Faston con-
nectors and connector receptacles for the airframe are in-
cluded in the scope of delivery.
Part number
MOLEX Crimping crap 64016-0035/63811-4400
MOLEX Disassembly tool 63813-1500
Strip cable (2) as required (A).
Use suitable crimping crap (3) to fit the Faston connector (B).
Press down white integral terminal position assurance (TPA) with needle nose
pliers until audible click is heard.
Push the Faston connector in the corresponding slot (4) of the Harness Inter-
face Connector receptacle until it is locked in place (C).
Check for tight fit.
The TPA pin holder must not be pressed pushed with ex-
cessive force.
Description
Procedure
24-00-00
Page 20
January 01/2014