To Set The Tod And The Date In Parameter Assignment Mode - Siemens Logo! Manual

Configuring LOGO!

To set the TOD and the date in parameter assignment mode:

1. Select parameter assignment mode (see Chapter 5.1.)
2. On the parameter assignment menu, select
'Set..':
Stop
Set Param
>Set..
Prg Name
3. Confirm 'Set..':
4. Move the '>' cursor to 'Clock':
5. Confirm 'Clock':
6. Move the '>' cursor to 'Set Clock':
7. Apply 'Set Clock':
Note
The 'Set Clock' command is only executed if your LOGO!
is equipped with a real-time clock (LOGO!..C). You set the
real-time clock of LOGO! by means of the 'Set Clock'
command.
LOGO! shows the following display.
Set Clock
Mo 15:30
YYYY-MM-DD
2005-01-27
8. Select the day of the week:
9. Move the cursor to the next position: Press
10.To change the value:
11. To set the correct TOD, repeat steps 9. and 10.
12.To set the correct date, repeat steps 9. and 10.
13.To confirm your entries:
242
The cursor is positioned
on the weekday.
Press or
Press OK
Press or
Press OK
Press or
Press OK
Press or
or
Press or
Press OK
LOGO! Manual
A5E00380835-01