Closing The Programming Mode; Deleting A Block; Logo! Is Back In Run Mode - Siemens Logo! Manual

Closing the programming mode

Although you were shown how to exit the programming
mode when you created your first circuit program,
here is a reminder:
1. To return to the programming menu:
2. To return to the main menu:
3. To move the '>' cursor to 'Start':
4. To confirm 'Start':

LOGO! is back in RUN mode:

Mo 09:30
2005-01-27

3.7.8 Deleting a block

Let us assume you want to delete the block B2 from your
circuit program and connect B1 directly to Q1.
I1
I2
x
Proceed as follows:
1. Switch the LOGO! to programming mode
(as a reminder, refer to Page 66).
2. Select 'Edit':
3. Confirm 'Edit':
(If required, enter your password and confirm with OK.)
4. Select 'Edit Prg':
5. Confirm 'Edit Prg':
LOGO! Manual
A5E00380835-01
B1
x
Par
Programming LOGO!
You can press
to scroll the pages and to monitor the I/O
states.
B2
Q1
Press ESC
Press ESC
Press or
Press OK
or
Press or
Press OK
Press or
Press OK
93