Siemens Logo! Manual page 219

To change 'Par' to 'Switch' action and the initialization sta-
tus after the program start:
4. To select 'Momentary pushbutton' or 'Switch' action:
B33
On/Off
Start=On
5. To change to the start state:
6. To change the start state:
B33
On/Off
Start=Off
7. Confirm your entries with
View in parameter assignment mode (example):
Here, you can set or reset the 'Switch' parameter (On/Off).
When in RUN, the LOGO! shows the following display:
B33
Switch=Off
Let us assume you want to set 'Switch' (On).
1. Change to the editing mode:
(the cursor is now positioned on 'Off')
2. To change from 'Off' to 'On':
3. Confirm your entries with
LOGO! Manual
A5E00380835-01
+/
The status is not retentive
'Switch' function
Q is set in the first cycle after the
program start
+/
The status is not retentive
'Switch'function
Q is reset in the init cycle after the
program start
The pushbutton/switch is here
switched off
LOGO! functions
Press or
Press or
Press or
OK
Confirm with OK
Press or
Press OK
211