Siemens Logo! Manual page 243

Description of the four menu items of the parameter assignment
menu
S
Stop
You select this command to stop your circuit program and
thus change to the main menu of programming mode. To
do so:
1. To move the '>' cursor to 'Stop':
2. To confirm 'Stop':
Stop Prg
>No
Yes
3. To move the '>' cursor to 'Yes':
4. To confirm 'Yes':
LOGO! shows the main menu of the programming mode:
>Program..
Card..
Setup..
Start
S
Set Param
For information on the various parameters, refer to the
Chapters 5.1.1 to 5.1.3.
S
Set..
For information on the various settings, refer to
Chapter 5.2.
S
Prg Name
This menu command only allows you to read the name of
your circuit program. It is not possible to modify this name
in parameter assignment mode (see Chapter 3.7.4).
LOGO! Manual
A5E00380835-01
Configuring LOGO!
Press or
Press OK
Press or
Press OK
235