Networking On The Eib Bus; Connecting The As Interface Bus - Siemens Logo! Manual

Press the button "Prog ↓" to switch the CM EIB/KNX to pro-
gramming mode.
Note
The button "Prog ↓" should not be pressed too firmly.
If the bus connection is OK, the LED lights up green.
In programming mode, the LED lights up orange.

Networking on the EIB bus

The CM EIB/KNX takes over the communication between
the LOGO! and EIB and makes communication available
via EIB inputs/outputs.
The application of the CM EIB/KNX fills the complete
LOGO! process image; i.e. inputs or outputs which are not
occupied on the LOGO! can be occupied via the EIB.
Note
For detailed information about the networking of LOGO! on
the EIB bus please refer to the LOGO! CM EIB/KNX docu-
mentation, in particular the Micro Automation Set 8.

2.3.5 Connecting the AS interface bus

You can set the address on the AS interface bus before or
after installation.
If the module is addressed via the address socket in the
installed condition, the AS-Interface voltage must be dis-
connected beforehand. This is necessary for safety
reasons.
LOGO! Manual
A5E00380835-01
LOGO! installation and wiring
43