Drilling template for wall-mounting
Before you can wall-mount the LOGO!, you need to drill
holes using the template shown below.
1
All dimensions in mm
Bore hole for O M4 screw
Tightening torque 0.8 to 1.2 N/m
LOGO! Basic
1
LOGO! expansion module
2
2.2.3 Labeling LOGO!
The gray rectangular areas on the modules are intended
for labeling the LOGO! modules.
In the case of expansion modules, you can use the gray
areas for labeling the inputs and outputs, for example. In
this connection, you can enter a delta factor of +8 for the
inputs or +4 for the outputs if the basic module already has
8 inputs or 4 outputs.
LOGO! Manual
A5E00380835-01
53.5 +/– 0.2
2
LOGO! installation and wiring
35.5 +/– 0.2
2
n x 35.5 +/– 0.2
2
29