Assigning Block Parameters; To Change The Time Value - Siemens Logo! Manual

Programming LOGO!
In our example we do not use the reset input of the off-
delay function, and we identify it with an 'x' connector.
B1
x
Par

Assigning block parameters

Now you set the off-delay time T:
1. Move the cursor to Par, if it not already at this position:
Press
2. Switch to editing mode:
LOGO! shows the parameters in the parameter assignment
window:
T: The block pa-
rameter B2 is a
time function

To change the time value:

S
Press
S
Press
tion.
S
Confirm your entries with OK.
90
B2
Q1
or
B2
T =00:00s
Time value
and to position the cursor.
and to modify the value at the relevant posi-
This is what the display should now show
Press OK
"+" means: The parameter
is shown and can be modi-
+R
fied in the parameter as-
signment mode.
"R" means: Retentivity is
enabled for this block.
Timebase
LOGO! Manual
A5E00380835-01