Device Control - Microscan MS-710 User Manual

Device Control

By ESP
Device Control By Serial Command
Output #1 Pulse
Sending <L1> pulses Output 1 (regardless of Master Symbol or Output 1 status).
Output #2 Pulse
Sending <L2> pulses Output 2 (regardless of Master Symbol or Output 2 status).
Disable Reader
Sending <I> will turn the laser off and end the current read cycle. This feature is useful
during extended periods of time when no symbols are being scanned or the scanner is
being configured. Disabling laser scanning will not affect any downloaded commands to
the scanner.
Note: Disable Laser Scanning does not relate to Laser On/Off, which when enabled
also turns off the laser but only between read cycles.
Enable Reader
Sending <H> will turn the laser on continuously.
Note: Enable Laser Scanning does not relate to Laser On/Off command.
MS-710 Scanner User's Manual
Chapter 9 Utilities
9-9