Microscan MS-710 User Manual page 184

Index
P
Parity
aux port 3-9
host port 3-3
Part Number, firmware 9-14
Partial Output 6-12
Percent Test 9-5
Picket Fence Calculation
Angled A-25
Single Scan Line A-25
Pin Assignments A-5
Pitch 1-7
Point-to-Point
standard 3-4
with RTS/CTS 3-5
with RTS/CTS & XON/XOFF 3-5
with XON/XOFF 3-5
Polling Mode D 3-5
Polling Sequence A-31
Position Symbol and Scanner 1-7
Postamble Characters 3-18
Power Supply 1-2
Preamble Characters 3-17
Protocol Commands A-18
Pulldown Menus 2-4
Pulse Width, I/O Parameters 6-17
R
Range A-26
Raster Height A-3
Raster Mirror A-3
Read Cycle 4-12
by ESP Menu 4-2
by Serial Command 4-2
Read Cycle Timeout 4-13
Read Ranges A-3
Read Rate 1-8, 9-5
Reflectance Threshold 4-17, A-15, A-16
Reset A-23
Response Timeout 3-20
Restore Commands A-20
Restore Microscan Defaults A-21
Restore Microscan Defaults <Ad> A-20
MS-710 Scanner User's Manual
I-4
Restore User-saved Settings A-20
Right-angle Down Scan Range/Width Graph
A-4
RJ-11 Cable A-9
RS-232 A-28
RS-232 Auxiliary Port 3-9
RS-232/422 Host Port 3-3
RS-422 A-28
RS-485 A-28
S
Safety Certifications A-4
Safety Labels 1-x
Save Active Settings except Factory for Pow-
er-on A-22
Save Active Settings including Factory for
Power-on A-22
Save Commands A-20
Saving 2-7
Saving settings A-22
Scan Range/Width Graph A-4
Scan Rate A-26
Scan Speed 4-15
Scan Width A-26
Scanner Setup 4-15
Scanner Status Byte 9-17
Scanner Status Requests 9-17
Scanner Type 4-17
Scanning Parameters A-3
Select Sequence A-32
Send/Receive Options 2-7
Separator Character
UPC/EAN 5-14
Sequence On Mismatch 7-8
Sequence On Noread, Matchcode 7-7
Sequential Matching, Matchcode 7-5
Serial Command Beep Status 6-14
Serial Command Echo Status 6-13
Serial Command Format A-13
Serial Command Status Request A-14
Serial Commands
Utilities 9-3
Serial Commands, concatenating A-14