Microscan MS-710 User Manual page 163

Appendices
Initializing
Initializing occurs whenever any command or set of commands is implemented.
Initializing is a part of all save and default functions. It is also used as a follow-on to
implement serial configuration commands.
• Initializes serial configuration commands into
< >
A Initialize
active memory and resets counters to zero.
• Does not save settings for power-on.
Active
By Serial Command
Memory
Send <A> after a serial configuration command or a
string of serial configuration commands, for exam-
User-Saved
Microscan
ple, <Kd1><A>.
Settings
Defaults
By ESP
Right-click in the configuration window and select Save to Reader, Send No Save.
This will initialize all serial configuration changes that have been made in the current
ESP session.
Note: Allow a 1 second delay after sending the <A> command before resuming com-
munications.
Loss of Communications
Making changes to communications with the host such as Baud Rate, Parity, Stop
Bits, LRC, etc. without corresponding changes in linked device(s) can result in the loss
of menu access through If this should occur, you should restore the scanner's defaults.
MS-710 Scanner User's Manual
A-23