Microscan MS-710 User Manual page 13

Chapter
1
Step 1 Hardware Required ......................................................................1-2
Step 2 Connect the System .....................................................................1-3
Step 3 Install ESP ....................................................................................1-4
Step 4 Select Scanner Model ..................................................................1-5
Step 5 Autoconnect .................................................................................1-6
Step 6 Position Symbol and Scanner ......................................................1-7
Step 7 Test for Read Rate .......................................................................1-8
Step 8 Configure the Scanner .................................................................1-9
This chapter is designed to get your scanner up and running quickly using Microscan's
ESP™ so the user can get a sense of its capabilities and test bar code symbol samples.
Detailed setup information for installing the scanner into the actual application can be
obtained in the subsequent chapters. ESP™ is Microscan's proprietary Easy Setup Pro-
gram, a Windows™ based graphic user interface that resides on the user's host com-
puter and allows the user to fully configure, test, and operate Microscan's 1D and 2D
symbology readers
As an alternative to ESP, you can setup the scanner by sending serial commands or by
using the scanner's embedded menus.
MS-710 Scanner User's Manual
Quick Start
Chapter Contents
1-1