Rs232 Timeout; Xon/Xoff - Honeywell HF680 Series User Manual

RS232 Timeout

When using Flow Control with Timeout, you must program the length of the delay
you want to wait for CTS from the host. Set the length (in milliseconds) for a
timeout by scanning the barcode below, then setting the timeout (from 1-5100
milliseconds) by scanning digits from the
Save.

XON/XOFF

Standard ASCII control characters can be used to tell the scanner to start sending
data (XON/XOFF On) or to stop sending data (XON/XOFF Off). When the host
sends the XOFF character (DC3, hex 13) to the scanner, data transmission stops.
To resume transmission, the host sends the XON character (DC1, hex 11). Data
transmission continues where it left off when XOFF was sent. Default = XON/XOFF
Off.
HF680 Series User Guide
Flow Control, No Timeout
Flow Control with Timeout
XON/XOFF On
Programming
RS232 Timeout
Two-Direction Flow Control
* RTS/CTS Off
Chart, then scanning
* XON/XOFF Off
25