Inspect Cords And Connectors; Replace Cables; Replace An Interface Cable - Honeywell HF680 Series User Manual

Inspect Cords and Connectors

Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable
replacement instructions are on

Replace Cables

The standard interface cable is attached to the scanner with a 10-pin modular
connector. When properly seated, the connector is held in the scanner's handle by
a flexible retention tab. The interface cable is designed to be field replaceable.
•
•

Replace an Interface Cable

1. Turn the power to the host system OFF.
2. Disconnect the scanner's cable from the terminal or computer.
3. Release the cable connector:
4. Replace with the new cable.
158
Order replacement cables from Honeywell or from an authorized distributor.
When ordering a replacement cable, specify the cable part number of the
original interface cable.
HF680 and HF680E:
a. Locate the small hole on the back of
the scanner. This is the cable
release.
b. Straighten one end of a paper clip.
c. Insert the end of the paper clip into
the small hole and press in. This
depresses the retention tab,
releasing the connector. Pull the
connector out while maintaining
pressure on the paper clip, then
remove the paper clip.
HF680M: depress the retention tab to
release the connector, then pull the
connector out.
Insert the connector into the opening
and press firmly. The connector is
keyed to go in only one way, and will click into place.
page 158.
HF680
Cable Release
HF680M
HF680E
Cable Release
Retention Tab
HF680 Series User Guide