Installation - Farmall 90 Manual

94
4. Remove the injectors (2) with tool 380000671 (1)
and extract them from the cylinder head.
5. Remove the threaded parts retaining the injec-
tors from the cylinder head.

Installation

To refit, proceed as follows:
CAUTION
Always use appropriate tools to align fixing
holes. NEVER USE FINGERS OR HANDS.
1. Fit the threaded parts retaining the injectors on
the cylinder head.
2. On the injector (1), mount a new seal (2) lubri-
cated with Vaseline and a new washer (3).
3. Fit the injectors in the seats on the cylinder head
and tighten them with a torque wrench to the
torque prescribed on page 12.
4. Fit the new seals on the fuel manifolds.
5. Fit the diesel delivery and recovery pipes and fit-
tings on the injectors.
6. Fit the air filter dust ejector pipe, its clamp and the
four rear nuts retaining the silencer to the ex-
haust manifold.
7. Fit the three rear retaining bolts of the exhaust si-
lencer.
8. Install the hood as described in opera-
tion 90 100 22.
9. Lower the hood and reconnect the battery nega-
tive cable.
SECTION 10 - - ENGINE - - CHAPTER 1
200
201