Farmall 90 Manual page 70

70
2. Direct the crankshaft (3) and camshaft (4) so that
when mounting the driven gear (1) on the cam-
shaft, the marks stamped on the gears (1 and 2)
coincide.
3. Place the dial gauge (1) on the timing gear (2)
and check that the clearance between the gears
(2) and (3) is between 0.076 to 0.280 mm (0.0029
to 0.0110 in).
4. Insert the screws (1) fixing the gears (2) to the
camshaft (3) and tighten them to the torque pre-
scribed on page 12.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF0978A
MIF1140A
MIF1141A
134
135
136