Installation - Farmall 90 Manual

92
9. Take the cylinder where the clearance is to be ad-
justed into the end--of--compression phase; the
valves in the cylinder are closed, whilst those on
the symmetrical cylinder are rocking.
-- The symmetrical cylinders are 1 -- 4 and 3 -- 2.
-- FIRING ORDER 1 -- 3 -- 4 -- 2
Balancing valves
of cylinder no.
Adjust valve clear-
ance of cylinder no.

Installation

Proceed as follows:
1. Fit the rear tappet inspection cover together with
the cover base seal and tighten the retaining bolt
to the torque stated on page 12.
2. Fit the central tappet inspection cover together
with the engine vapor inlet pipe and the cover
base seal, then tighten the retaining bolts to the
torque stated on page 12.
3. Fit the front tappet inspection cover together with
the cover base seal and tighten the retaining bolt
to the torque stated on page 12.
4. Reposition the cab water delivery--return pipes
and those of the electric cables, inserting new
plastic retaining clamps.
5. Insert the intake manifold--air filter connecting
pipe on the intake manifold and insert the retain-
ing clamp.
6. Install the hood as described in opera-
tion 90 100 22.
7. Reconnect the battery negative lead.
SECTION 10 - - ENGINE - - CHAPTER 1
1 3 4 2
4 2 1 3