Installation - Farmall 90 Manual

Installation

To install proceed as follows:
CAUTION
Always use appropriate tools to align fixing
holes. NEVER USE FINGERS OR HANDS.
1. Respect the tightening torques prescribed on
page 12.
2. Fit the upper rubber blocks (2), washers and the
rubber block at the base of the radiator.
3. Fit the radiator.
4. Fit the lower rubber blocks, the washers and the
radiator retaining bolts installed under the front
axle support.
5. Fit the radiator coolant compensation reser-
voir and the retaining clamp.
6. Fit the radiator retaining bracket to the hood sup-
porting bracket, then tighten the retaining bolt.
7. Fit the upper radiator--thermostat valve connect-
ing sleeve and the relevant clamp.
8. Fit the sleeve connected to the bottom of the wa-
ter radiator and its clamp.
9. Fit the engine oil vapor suction pipe and its
clamp.
10. Fit the air filter and tighten the two lower retaining
bolts.
11. Fit the air filter/exhaust ejector connecting pipe
and its clamp.
12. Fit the sleeve connected to the intake manifold
and its clamp.
13. Fit the sleeve connected to the air filter and its
clamp.
14. Install the fitting of the cab heater radiator coolant
return pipe connected to the bottom of the cool-
ant pump.
15. Refill the engine radiator with coolant.
16. Refit the guard on the right--hand side of the fan
and tighten the three retaining bolts.
17. Install the condenser (operation 50 200 72) with
the relevant delivery/return pipes.
18. Reconnect the battery negative cable and close
the hood.
SECTION 10 - - ENGINE - - CHAPTER 1 111