Farmall 90 Manual page 48

48
40. Screw two pins (2) of the appropriate length into
the holes in the crankshaft (3).
41. Extract the engine flywheel (1) so it can be slung
with the lift and put it away in a specific container.
Removing the Crankshaft Rear Seal
(Op. 42. to 45.)
42. Extract the seal, applying tool 380000663 (3)
onto the rear shank (1) of the crankshaft.
43. Perforate the inner seal (5) with a drill bit
(∅ 0.1377 in. (3.5 mm)) through the guide holes
of the tool 380000663 (3), for a depth of
0.1968 in. (5 mm).
44. Secure the tool 380000663 (3) to the seal (5) by
screwing down the screws (2) supplied.
45. Extract the seal (5) by screwing down the screw
(4).
46. Take out the screws (2) and remove the timing
gear box (1), retrieving the injection pump gear.
NOTE: Note down the assembly position of the
screws (2) as they have different sizes.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1116A
MIF0927A
MIF1125A
70
71
72