Timing - Farmall 90 Manual

100
12. Reconnect the pipe installed between the fuel fil-
ter and the fuel pump and reinsert the quick cou-
plers.
13. Fit the pipe supplying the injection pump, con-
necting the quick couplers on the filter and on the
injection pump.
14. Fit the pipe coming from the tank.
15. Reconnect the engine stop electromagnet cable.
16. Fit the throttle control lever and its retaining clip.
17. Install the hood.
18. Reconnect the battery negative cable and lower
the hood.

Timing

When replacing the injection pump, bear in mind that
it is supplied as a spare part already set for cylinder
No. 1 at T.D.C.
Proceed as follows:
1. Unscrew the bolts (1) and remove the starter mo-
tor (2).
2. Fit the bracket tool 380000988 (1), retaining the
gear for turning the engine flywheel tool
380000732 (2).
3. Slowly turn the engine flywheel (3) and at the
same time press on the pin (4), supplied with tool
380000988, in order to insert the pin (4) into the
seat in the engine flywheel (3).
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1172A
MIF1173A
214
2
3
215