Fitting The Oil Sump - Farmall 90 Manual

Fitting the Oil Sump

(Disassembly operation 34.)
1. Place the new seal on the crankcase.
2. Fit the oil sump (1).
3. Insert the screws (3) and tighten them to the
torque prescribed on page 12.
4. Tighten the drain plugs (2) to the torque pre-
scribed on page 12.
Fitting the Crankshaft Front Seal
(Disassembly operations 29. to 33.)
1. Fit part (4) of tool 380000666 on the front shank
(3) of the crankshaft.
2. Secure it with the screws (5) and spline the new
seal (6) onto it.
3. Position part (1) on part (4), screw down the nut
(7) until the seal (6) is completely fitted in the front
cover (2).
Fitting the Crankshaft Front Pulley
(Disassembly operation 28.)
1. Spline the pulley (2) onto the crankshaft.
2. Tighten the screws (1) to torque and angle (see
page 13), using tool 380000304.
SECTION 10 - - ENGINE - - CHAPTER 1
1
MIF1117A
MIF1001A
MIF1111A
77
2
155
156
157