Farmall 90 Manual page 53

59. The piston pin (1) retaining rings (2) should be re-
moved using a marking tool (3).
60. Take out the screws (1) and remove the main
bearing caps (2).
61. The penultimate main bearing cap (1) and the re-
lated mounting have the half bearing (2)
equipped with a shoulder. Remove the pistons
with the connecting rods.
NOTE: Note down the assembly position of the top
and bottom half bearings since, if they are reused,
they must be mounted in the position found upon dis-
assembly.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF0951A
MIF1126A
MIF0940A
53
85
86
87