Fitting The Oil Pump - Farmall 90 Manual

76
4. Spline the flywheel (1) onto the crankshaft, tight-
ening the screws (2) by hand.
5. Lock the flywheel appropriately before tightening
the relevant screws to torque.
6. Tighten the bolts (1) securing the engine flywheel
(2) in two stages as described on page 13:
st
- 1 phase,
wrench to a torque of 30 ± 5 Nm;
nd
- 2 phase, tightening to an angle of 60°
± 5°.
NOTE: Tightening to an angle is done with tool
380000304.

Fitting the Oil Pump

(Disassembly operation 35.)
1. Insert the seal.
2. Fit the oil pump (1).
3. Insert the tightening screws (2) and tighten them
to the torque prescribed on page 12.
SECTION 10 - - ENGINE - - CHAPTER 1
tightening with torque
MIF1115A
MIF1146A
MIF1149A
152
153
154