Valve-Rocker Arm Clearance - Farmall 90 Manual

3. Manually tighten the bolts (2) retaining the fly-
wheel (1) to the crankshaft.
4. Tighten the bolts (1) securing the engine flywheel
(2) in two successive stages as described on
page 13:
st
-- 1 phase, tightening with torque wrench to
a torque of 30 ± 5 Nm;
nd
-- 2 phase, tightening to an angle of 60° ± 5°.
NOTE: Tightening to an angle is done with tool
380001001.
5. Refit the clutch as described in opera-
tion 18 110 10.
Op 10 106 12
VALVE- -ROCKER ARM CLEARANCE
Removal
WARNING
Handle all parts carefully. Do not put your hands
or fingers between parts. Wear the prescribed
safety clothing, including goggles, gloves and
safety footwear.
1. Remove the hood (1) as described in opera-
tion 90 100 22.
2. Disconnect the battery negative lead.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1115A
MIF1146A
89
189
190
191