Fitting The Piston Connecting Rod Assemblies In The Cylinder Liners - Farmall 90 Manual

4. Fit the half bearings (1) on the connecting rod
and cap.
NOTE: If the crankpins of the crankshaft are under-
sized it is necessary to replace the big end bearings
of the same undersize class made.
Do not modify the half bearings in any way.
Fitting the Piston Connecting Rod Assemblies in
the Cylinder Liners
(Disassembly operation 57.)
1. Lubricate the pistons well, including the piston
rings and the inside of the cylinder liners.
2. With the aid of the ring clamp 380000220 (2), fit
the connecting rod--piston assemblies (1) in the
cylinder liners.
3. The ring openings must be staggered apart by
120°;
4. The connecting rod/piston assemblies must all
have the same weight;
5. The arrow (1) stamped on the crown of the pis-
tons must face the auxiliary member side of the
engine and the recess in the piston skirt must cor-
respond to the position of the oil nozzles.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF0970A
MIF0971A
MIF0972A
63
113
114
115