Installation - Farmall 90 Manual

86

Installation

To fit the front seal on the crankshaft, proceed as fol-
lows:
1. Fit part (4) of tool 380000666 on the front shank
(3) of the crankshaft. Secure it with the screws (5)
and spline the new seal (6) onto it. Position part
(1) on part (4), screw down the nut (7) until the
seal (6) is completely fitted in the front cover (2).
2. Fit the fan--alternator--coolant pump pulley, the
accessory assembly pulley and the six retaining
bolts.
3. Refit the transmission belt on the pulleys, adjust
it with the tensioning screw and lock the tighten-
er, tightening the two retaining and pivot screws.
4. Refit the engine radiator as described in opera-
tion 10 406 10.
5. Refit the condenser radiator, see opera-
tion 50 200 72.
6. Reconnect the negative battery cable and close
the hood.
Op 10 102 74
CRANKSHAFT REAR SEAL
Removal
DANGER
Lift and handle all heavy parts using suitable lift-
ing equipment.
Make sure that assemblies or parts are sup-
ported by means of suitable slings and hooks.
Check that no one is in the vicinity of the load to
be lifted.
To access the seal, proceed as follows:
1. Remove the clutch as described in opera-
tion 18 11 010.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1001A
182
183