Farmall 90 Manual page 43

7. Remove the intake manifold (2).
8. Disconnect the engine oil vapor recovery pipe
from the blow--by (3).
9. Remove the tappet covers (1).
10. Remove the pipes with the quick--fit coupling (6)
and (8).
11. Remove the piping from the LDA system (5).
12. Remove the fuel filter (7).
13. Remove the heater (4).
14. Remove the control unit for the heater (10).
15. Remove the fuel filter support (9).
16. Act on the fork (1) as shown in the figure 56
(part B) and remove the fitting. To avoid deforma-
tion, with the fitting removed, put the fork (1) back
in the locking position (part A).
NOTE: Figure 56 shows the connectors for the low- -
pressure pipes (6 and 8, figure. 55).
A = Pipe locking position on connector.
B = Pipe removal position on connector.
17. Remove the injector feed pipe (4) from the injec-
tion pump (3).
18. Remove the brackets on the cylinder head of the
pipe assembly (1), (2) and (6).
19. Remove the priming pump (5).
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1105A
MIF0909A
MIF1107A
43
55
56
57