Installation - Farmall 90 Manual

106
6. Take out the bolts (1) retaining the thermostat
valve body (2).
7. Remove the thermostat valve body (2), seal (3)
and thermostat valve (4).

Installation

To refit the thermostat valve, proceed as follows:
CAUTION
Always use appropriate tools to align fixing
holes. NEVER USE FINGERS OR HANDS.
1. Respect the tightening torques prescribed on
page 12.
2. Refit the thermostatic valve, after positioning the
thermostat valve seal.
3. Fit the thermostat valve body and the retaining
bolts.
4. Fit the radiator--thermostat valve connecting
sleeve and the clamp.
5. Install the fitting of the cab heater radiator coolant
return pipe connected to the bottom of the cool-
ant pump and refill the engine coolant.
6. Fit the guard on the right--hand side of the fan and
tighten the three retaining bolts.
7. Reconnect the battery negative lead.
8. Close the hood.
SECTION 10 - - ENGINE - - CHAPTER 1
230
231