Engine Assembly On The Bench; Fitting The Bushings - Farmall 90 Manual

56
NOTE:
-- After disassembling the engine, thoroughly clean
the parts.
-- Pages (56--83) show the assembly operations
that require extra attention in order to assemble
parts correctly.
-- The torque settings are shown on pages 12 and
13.
IMPORTANT:
-- When partially or fully disassembling the engine,
all seals must be replaced.
-- Before inserting rotating parts and seals in seats,
lubricate the parts with engine oil.
-- When fitting the oil filter, lubricate the seal with
engine oil.
CAUTION
Handle all parts carefully.
Do not put your hands or fingers between parts
and use appropriate tools to align fixing holes.
Wear the prescribed safety clothing, including
goggles, gloves and safety footwear.

ENGINE ASSEMBLY ON THE BENCH

Fitting the Bushings

(Disassembly operation 68.)
-- To remove and renew the front and rear bushings
(1) of the camshaft, use the drift 380000667 (2)
and grip 380000668 (3).
NOTE: The bushings (1) must be directed so that the
lubrication holes coincide with the holes in the seats
in the crankcase.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1130A
94