Fitting The Injectors - Farmall 90 Manual

68
10. Before inserting the control rods, check that the
spherical seat (1) of contact with the rocker arm
adjuster screw and the spherical end (2) of con-
tact with the tappet show no sign of wear; if there
are, then change them. The inlet and exhaust
valve control rods are identical and can therefore
be interchanged.
-- Spread LOCTITE 5999 sealant between the cov-
er (2) and the manifold (3) and tighten the screws
(1) to the torque prescribed on page 12.

Fitting the Injectors

(Disassembly operation 50.)
1. On the injector (1), mount a new seal (2) lubri-
cated with Vaseline and a new washer (3).
2. Fit the injectors 2, 3, 4 in the seats on the cylinder
head and tighten them to the torque prescribed
on page 12.
SECTION 10 - - ENGINE - - CHAPTER 1
MIF1011A
MIF1094A
MIF1063A
128
129
130