Farmall 90 Manual page 41

31. Refit the silencer together with the exhaust pipe.
32. Secure the silencer to the exhaust manifold with
the four nuts and connect the air filter dust extrac-
tor pipe to the silencer exhaust, inserting the re-
taining clamp.
33. Refit the three rear retaining bolts of the exhaust
silencer.
34. Fit the cab heater delivery and return pipes and
insert the associated clamps.
35. Refit the fitting of the hose delivering power
steering oil to the hydraulic cylinders governing
the front wheel steering.
36. Install the flexible cables governing the hand and
pedal throttle, inserting the retaining clips.
37. Reconnect the throttle control tie--rod to the injec-
tion pump, inserting the retaining clip.
38. Working from inside the cab, fit the four plugs to
gain access to the upper bolts securing the en-
gine, located at the base of the steering column.
39. Refit the pedal on the differential lock drive shaft,
the retaining pin and the footboard.
40. Refit the two right-- and left--hand dashboard
panels and the relevant four fixing knobs.
41. Refit the two power steering cylinder oil delivery
and return hoses.
42. Install the electrical connections between the
cab and the engine.
43. Reconnect the diesel delivery and return pipes to
the diesel pump and install the relevant plastic
fasteners.
SECTION 10 - - ENGINE - - CHAPTER 1
44. Working on the left--hand side of the engine,
install the lift pump draw pipe and tighten the re-
taining bolts.
45. Install the delivery pipe of the services pump on
the right--hand side of the engine and tighten its
fitting.
46. Refit the rigid pipe for drawing oil from the trans-
mission and the two metal clamps.
47. Refit the power steering/four--wheel drive drain
pipe on both the left-- and right--hand sides of the
engine.
48. Refit the lift pump draw pipe and lock the retain-
ing bolts.
49. Refit the propeller shaft with its central support
and the retaining bolts.
50. Refit the front axle drive shaft guard, tightening
the front, central and rear retaining bolts.
51. Refit the front ballast together with the support
and insert the retaining pin and the split pins.
52. Install the fitting of the cab heater radiator coolant
return pipe connected to the bottom of the cool-
ant pump and refill the engine coolant.
53. Refit the guard on the right--hand side of the fan,
tightening the three retaining bolts.
54. Refill the transmission--gearbox housing with oil.
55. Install the hood. Reconnect the battery negative
lead.
41