Table of Contents
Advertisement
...7.3 Factory Settings
-----
FACTORY SETTINGS
0000
Factory Set Code
-----
Cal. Sensor A
Yes
-----
No
Calibrate I/P ?
No
Factory Settings Access Code
Enter the required code number (between 0000 and 19999) to gain access to the factory
settings. If an incorrect value is entered, access to subsequent frames is prevented and the
display reverts to the top of the page.
Calibrate Sensor A
Note. The values in the display lines for sensor calibration are shown only as examples –
the actual values obtained will differ.
Sensor B calibration (dual input analyzers only) is identical to Sensor A
Cal. Sensor B
calibration.
Single input analyzers only – see page 66.
Cal. Output 1
Conductivity
Operating Page – see Section 2.3.
Dual Cond.
Calibrate Input for Sensor A ?
If calibration is required select
Note. To abort calibration, press the
complete – see next page.
Yes
Continued on next page.
A: Res.Zero (O/C)
otherwise select
.
Yes
No
key again at any time before calibration is
7 CALIBRATION...
63
Advertisement
Table of Contents
