...5 PROGRAMMING
5.5 Configure Outputs
-----
CONFIG. OUTPUTS
-----
Config. Output 1
% Pass
Temp.B
Sen.B
Temp.A
-----
Sen.A
AO1: Assign
34
Configure Output 1
Output 2 configuration (and Outputs 3 and 4 if option board fitted and analog
Config. Output 2
features enabled – see Section 7.3) is identical to Output 1 configuration.
Assign
Select the sensor and analog output required:
Sen.A
– Conductivity for the selected sensor.
Sen.B
Temp.A
– Temperature for the selected sensor.
Temp.B
Notes.
•
and
are applicable only to dual input analyzers.
Sen.B
Temp.B
• If
(dual input analyzers only) is set to any parameter other than
Signal Calc.
(page 28), the selected parameter is displayed:
Calculation
% Pass
–
Signal Calc.
% Rej
–
Signal Calc.
A – B
–
Signal Calc.
A/B
–
Signal Calc.
pH
–
Signal Calc.
(see Appendix A3 for further information on inferred pH)
Continued on next page.
AO1: Range
set to
% Passage
set to
% Rejection
set to
Difference A – B
set to
Ratio A/B
set to
,
Inf.pH(NH3)
Inf.pH(NH3+NaCl)
No
or
Inf.pH(NaOH)