...6.3 Connections, General
6.3.2 Cable Entry Knockouts, Wall-/Pipe-mount Analyzer – Fig. 6.7
The analyzer is supplied with 7 cable glands, one fitted and six to be fitted, as required, by the user – see Fig. 6.7.
Release the four captive
screws and remove
the terminal cover plate
Secure the cable
gland with the nut
1
6
Insert the cable gland into the hole
5
in the analyzer case from the outside
Fig. 6.7 Cable Entry Knockouts, Wall-/Pipe-mount Analyzer
Factory-fitted cable gland
Place the blade of a small, flat bladed screwdriver
2
into the knockout groove and tap the
screwdriver smartly to remove the knockout
(see Note below)
Note. When removing knockouts, take
great care not to damage wiring and
components within the analyzer.
Smooth the edges of the hole
3
with a small round or half-round file
4
Fit an 'O' ring seal to the the cable gland
6 INSTALLATION...
Cable entry knockouts
55