ABB AX410 User Manual page 9

...2.3 Operating Page
2.3.2 Dual Input Conductivity
0. 8 83
uS/cm
0. 8 92
uS/cm
Dual Cond.
0. 8 86
uS/cm
0. 8 95
uS/cm
@ 25 Deg.C
25. 6
Deg.C
24. 4
Deg.C
Temperature
Dual Cond.
Measured Conductivity
Sensor A.
Sensor B.
Notes.
• is displayed only if
Dual Cond.
below for an explanation of calculations.
• The displayed conductivity readings are the actual values of the sample.
• AX455 analyzers only – If
displayed conductivity reading for that sensor is the uncompensated conductivity
value of the sample, i.e. its value at its measured temperature (see below).
Temperature Compensated Conductivity – AX455 Analyzers Only
Sensor A.
Sensor B.
Notes.
• This frame is displayed only if
see Section 5.3.
• If for a sensor is set to
Cond.Units
reading for that sensor is the temperature compensated value, i.e. the value it would be
at a sample temperature of 25C (77F).
Measured Temperature
Sensor A.
Sensor B.
Note. The displayed temperature readings are the actual values of the sample.
See Section 3.1.
VIEW SETPOINTS
set to
Enable Cals.
SENSOR CAL.
set to
Enable Cals.
SECURITY CODE
(Section 5.9) – see Section 5.1.
set to
Enable Cals.
CONFIG. DISPLAY
(Section 5.9) – see Section 5.2.
is set to
Signal Calc. No Calculation
for a sensor is set to
Cond.Units
for either or both sensors is set to
Cond.Units
(Section 5.3), the displayed conductivity
USP645
(Section 5.3) – see Section 4.1.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
2 OPERATION...
– see Section 5.3. See
(Section 5.3), the
USP645
–
USP645
not set to zero
set to zero
7