Configure Power Failure Recovery Mode - ABB AX410 User Manual

...5 PROGRAMMING
...5.8 Configure Control

5.8.2 Configure Power Failure Recovery Mode

----
Power Recovery
Last
Manual
----
Auto
Power Rec. Mode
50. 0
%
Default Output
Power Recovery
46
Power Failure Recovery Mode
When power to the analyzer is restored,
according to the Power Failure Recovery Mode selected in this frame.
Select the required mode:
Auto –
Control Mode
failure.
Manual –
Control Mode
failure.
Control Output
frame below.
Output
Last –
Control Mode
to the power failure.
Default Output
Set the default output required after Power Failure Recovery, between 0 and 100% in 0.1%
increments.
Note. A setting of 0% represents no output.
Return to main menu.
CONFIG. CONTROL
See Section 5.9.
CONFIG. SECURITY
(Section 2.3) is set automatically
Control Mode
is set to irrespective of its setting prior to the power
Auto
is set to irrespective of its setting prior to the power
Manual
(Section 2.3) is set to the level set in the
and are set to the same state as that set prior
Control Output
Default