Single Input Conductivity - ABB AX410 User Manual

...2 OPERATION
2.3 Operating Page

2.3.1 Single Input Conductivity

0. 8 83
uS/cm
24. 8
Deg.C
Conductivity
0. 8 83
uS/cm
----
Manual
Control Mode
0. 8 83
uS/cm
60. 0
% Man.
Setpoint 90.0
1. 0 00
uS/cm
150. 0
%Sat
Control Setpoint
0. 8 86
uS/cm
@ 25 Deg.C
Conductivity
6
Measured Values
Conductivity.
Temperature.
Notes.
• The displayed conductivity and temperature readings are the actual measured values
of the sample.
• AX450 analyzers only – if
conductivity reading is the uncompensated conductivity value of the sample, i.e. its
value at the displayed temperature.
Control Mode
Conductivity value.
Control mode.
Use the and keys to switch between manual (
Note. Displayed only if
Controller
Control Output
Conductivity value.
Control output (%), manual (
When is set to
Control Mode
control output between 0 and 100%.
Note. Displayed only if
Controller
Control Set Point
Conductivity value.
Control set point.
Use the and keys to adjust the control set point between 0 and 250% conductivity.
Note. Displayed only if
Controller
Temperature Compensated Conductivity Value – AX450 Analyzers Only
Notes.
• This frame is displayed only if
• The displayed reading is the temperature compensated conductivity value i.e. the
value it would be at a sample temperature of 25C (77F).
See Section 3.1.
VIEW SETPOINTS
set to
Enable Cals.
SENSOR CAL.
set to
Enable Cals.
SECURITY CODE
(Section 5.9) – see Section 5.1.
set to
Enable Cals.
CONFIG. DISPLAY
(Section 5.9) – see Section 5.2.
is set to
A: Cond.Units USP645
Manual
is set to – see Section 5.7.
PID
) or automatic ( ).
Man Auto
(see above), use the
Manual
is set to – see Section 5.7.
PID
is set to – see Section 5.7.
PID
is set to
A: Cond.Units
(Section 5.3) – see Section 4.1.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
(Section 5.3), the displayed
) and automatic ( ) control.
Auto
and keys to adjust the
– see Section 5.3.
USP645
not set to zero
set to zero