Setting Test Signal Off Timing - Hioki 3154 Instruction Manual

_____________________________________________________________________

6.1.6 Setting TEST Signal OFF Timing

The following shows two options when external I/O TEST
signal output returns from LOW to HIGH after completing
test. Factory setting is set to SLOW.
(1) SLOW (SLO)
(2) FAST (FASt)
(1) During READY status, press SHIFT key and press and
(2) Press ▲/▼ key to display "tESt SIGnAL"
(3) Press STOP key to display either "tESt SLO" or "tESt
(4) Press
(5) After selecting "SLO" or "FASt", press STOP key to
Just to verify setting, just go to setting display. After
verifying blinking indicator, press STOP key to return to
READY status.
______________________________________________________________
After completing test, maintains LOW (same status
during test) until voltage goes down to approximately
10 V in tested equipment during discharge.
Regardless of discharging status, returns to HIGH
almost simultaneously after completing test.
Setting TEST signal OFF timing
hold VOLT key approximately two seconds or longer to
display "SPECIAL".
FASt" blinking and display appears to set TEST signal
to OFF timing. ("tESt" does not blink.)
/ key to switch blinking displays "SLO" and
"FASt".
confirm option and returns to READY status.
Verifying setting
57
External Interface