System Reset - Hioki 3154 Instruction Manual

46
_____________________________________________________________________

5.4 System Reset

System reset is used to set all test conditions back to initial
factory settings. All saved test conditions are cleared by
system reset.
(1) During READY status, press SHIFT key then press and
(2) Press ▲/▼ key several times to display "rESEt".
(3) Press STOP key and all indicators are turned on. After
Factory Settings
Test voltage
Lower limit value
Test mode
Test duration
Delay time
Resistance range
Judgment beep sound
Sampling rate
Push switch probe mode
Beep sound during key press
Connection with RS-232C
External I/O TEST signal OFF timing
External I/O VOLT 0 to 2 signals
Analog output setting
______________________________________________________________
Other Functions
Executing system reset
hold VOLT key for approximately two seconds or
longer to display "SPECIAL".
displaying "Product name" and "Software version",
returns to READY status completing system reset.
25 V
OFF (displays [----])
Continue mode
OFF (displays [--])
OFF (displays [--])
Auto range
FAIL
FAST
Continue mode
ON
PC
SLOW
VOLT
FULL RANGE