Start Testing - Hioki 3154 Instruction Manual

_____________________________________________________________________

4.2 Start Testing

To avoid the risk of electric shock,c do not touch
equipment to be tested, probe tips and measurement
WARNING
terminals when TEST lamp is on or blinking.
Do not touch equipment to be tested, probe tips and
measurement terminals immediately after testing. High
voltage charge may result in electric shock.
To avoid the risk of electric shock, After testing,
proceed with discharge function to discharge charge in
tested equipment. (See 4.6.)
During READY status, press START key to start testing in
TEST status with TEST lamp ON.
To start and end testing, in addition to keys, 3154 DIGITAL
NOTE
MΩ HiTESTER is equipped with external I/O, RS-232C and
probes with switch. Different ways can be used to start and to
end testing.
Check and see if test probes are securely connected before
testing.
When external I/O STOP signal is set to LOW, testing does not
start.
______________________________________________________________
31
START key
Testing