Loading Test Conditions - Hioki 3154 Instruction Manual

44
_____________________________________________________________________

5.2.2 Loading Test Conditions

Saved test conditions can be loaded from internal memory.
(1) During READY status, press SHIFT key and then
(2) Press
(3) Press STOP key. Display "LOAD No." appears blinking
(4) Each indicator displays loaded conditions.
When loading with test voltage setting signal input through
NOTE
external I/O, following loaded conditions; test voltage, lower
limit value and test mode become invalid defaulting to external
I/O setting even after pressing START key.
When no condition setting is saved, loading display shows "--"
in stead of number. In this case pressing
switch displays.
______________________________________________________________
Other Functions
Loading saved test conditions
key. Following indicator appears displaying a number
blinking. The number identifies saved test condition
setting.
/ key to select option to load. Does not
display numbers not in use.
approximately two seconds and returns to READY
status completing loading test condition.
To return to READY status without loading test
conditions, press any key except STOP key and
key.
/
/ key does not