Setting 9299 Switched Probe - Hioki 3154 Instruction Manual

38
_____________________________________________________________________

4.7.2 Setting 9299 SWITCHED PROBE

Select either continue mode (cont) or trigger mode (trig) to
set 9299 SWITCHED PROBE.
(1) During READY status, press SHIFT key then press and
(2) Press ▲/▼ key to display "9299 ProbE".
(3) Press STOP key and "9299 Cont" or "9299 triG" appear
(4) Press
(5) Display blinking "Cont" to switch to continue mode and
______________________________________________________________
Testing
Operation Setting
hold VOLT key for approximately two seconds or
longer to display "SPECIAL".
blinking to show display to select and set Push Switch
probe mode setting. (Display "9299" does not blink.)
Continue mode
Trigger mode
/ key to switch blinking display with "Cont"
or "triG".
"triG" to trigger mode and press STOP key. After
pressing STOP key, probe operation mode is confirmed
and returns to READY status.