Completing Testing - Hioki 3154 Instruction Manual

34
_____________________________________________________________________

4.5 Completing Testing

To avoid the risk of electric shock, disconnect probe
from tested object after TEST lamp is turned off after
WARNING
testing is complete.
(1) After ending testing by one of three following ways,
(2) After returning to READY status, previously displayed
(3) TEST lamp may not turn off and continue to blink after
(4) After TEST lamp is turned off, remove probes from
______________________________________________________________
Testing
returns to READY status.
Press STOP key to stop testing.
Designated testing time passes and stops testing.
When test mode is set at FAIL STOP mode, FAIL
judgment stops testing.
measurement value and judgment result display lamp at
testing completion continue to display.
testing is complete indicating discharging any charge
buildup in tested object and the 3154.
Proceed with discharge by following instruction in 4.6
Automatic Discharge.
tested equipment.