Testing With 9299 Switched Probe - Hioki 3154 Instruction Manual

36
_____________________________________________________________________

4.7 Testing with 9299 SWITCHED PROBE

Optional 9299 SWITCHED PROBE permits control starting
and stopping 3154 operation while probe is held in hand.
Before testing, set push switch probe mode to either trigger
mode or continue mode. (See 4.7.2 to set mode.) The
3154 initial setting is set to continue mode.
(1) Continue Mode
(2) Trigger Mode
The same operations are applicable in both TEST status and
NOTE
READY status.
9299 SWITCHED PROBE can be used as an ordinary probe
when switch signal lead plug is not connected to EXT SW
terminal.
When external I/O STOP signal is set to LOW or the 3154
STOP key is pressed, testing cannot be initiated.
______________________________________________________________
Testing
Only when pressing ON switch, continues TEST status.
During READY status, press switch to start testing.
Release switch to terminate testing.
Press switch to start testing. TEST status continues
even after releasing switch. Press switch to terminate
testing in TEST status.
2
3
1. Push switch
2. Switching signal lead plug
3. Measurement plug
1
Functions as external switch for the
3154 START key and STOP key.
Connects to the 3154 EXT SW
terminal.
Connect to the 3154 measurement
terminal.