Terminal Connector Board/Signal Wires - Hioki 3154 Instruction Manual

48
_____________________________________________________________________

6.1.1 Terminal Connector Board/Signal Wires

1
START
STOP
VOLT0,VOLT1,
VOLT2
TEST
PASS
FAIL
EXT.DCV
______________________________________________________________
External Interface
Pin number
1, 2
3
4
14
5
6
7
8
9
10
11
12
13, 14
Set signal to LOW to enable same function as
pressing 3154 START key. To perform start up
edge detection, it requires more than 60 ms when
set to LOW. Locking on LOW does not release
continuous START signal input. In this case STOP
signal is accepted for input.
Set signal to LOW to enable same function as
pressing 3154 STOP key. To perform start up edge
detection, it requires more than 60 ms when set to
LOW. Locking on LOW does not accept "all test
start" for input.
Combination of these signals enables selection from
six test voltages (including comparator) options or
from seven saved test condition options. See 6.1.5.
During TEST status, selects LOW. Set with options
either to wait until after discharging charge in tested
equipment after completing test or not to wait and
returns to HIGH. See 6.1.6.
Selects LOW when comparator gives PASS
judgment.
Selects LOW when comparator gives FAIL judgment.
Terminal to supply power from external equipment.
Power supply voltage range is 5 to 30 VDC.
Supplies power also by connecting with INT.DCV
terminal.
IN/OUT Signal name
OUT INT.GND
IN EXT.COM
OUT FAIL
OUT PASS
OUT TEST
IN VOLT2
IN VOLT1
IN VOLT0
IN STOP
IN START
IN EXT.DCV
OUT INT.DCV