Setting And Verifying Delay Time - Hioki 3154 Instruction Manual

_____________________________________________________________________

3.4.2 Setting and Verifying Delay Time

Delay time is used to set test duration lock out time for
timer function and PASS/FAIL judgment by comparator
immediately after testing starts and voltage is applied.
Measurement value is displayed.
Same delay time setting is applicable at any test voltage.
For details, read 3.4.3 Determining Delay time.
(1) During test duration setting status, press STOP key or
(2) Press
(3) Press STOP key or TIMER key to confirm delay time.
(1) During delay time setting status, press both
(2) When "--" is blinking, press STOP key or TIMER key.
(3) Returns to READY status. In this case, testing is
______________________________________________________________
Setting Delay Time
TIMER key to automatically change and display delay
time settings display.
Timer display and DELAY lamp start blinking.
/ key to display desired delay time on timer
indicator.
Hold / key down to speed up adjustment of timer
control. (units in [seconds], setting range: 0.1 s to 99 s)
After determining, automatically returns to READY
status and DELAY lamp is turned on.
Timer indicator displays selected test duration.
When Not Setting Delay Time
key at the same time to display "--" blinking or hold
down either
performed as 0 second delay time.
DELAY lamp
key or key to display "--" blinking.
Setting Basic Testing Conditions
21
key and