Xconfiguration Standby Wakeupaction; Xconfiguration Standby Wakeuponmotiondetection; Xconfiguration Standby Powersave - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Standby WakeupAction

Define the camera position when leaving standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
USAGE:
xConfiguration Standby WakeupAction:
where
WakeupAction
: None/RestoreCameraPosition/DefaultCameraPosition
None: No action.
RestoreCameraPosition: When the video system leaves standby, the camera returns to
the position that it had before entering standby.
DefaultCameraPosition: When the video system leaves standby, the camera moves to
the factory default position.

xConfiguration Standby WakeupOnMotionDetection

Automatic wake up on motion detection is a feature that will sense when a person walks into
the room. The feature is based on ultrasound detection, and the Proximity Mode setting must
be On to make the feature work.
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration Standby WakeupOnMotionDetection:
where
WakeupOnMotionDetection
: Off/On
Off: The wake up on motion detection is disabled.
On: When people walk into the room the system will automatically wake up from
standby.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
WakeupAction
WakeupOnMotionDetection
xCommand

xConfiguration Standby PowerSave

You can reduce the video system's power consumption during out-of-office hours with this
setting. The Power Save mode is an extension to the regular standby mode.
When the video system enters power save mode, power is cut to some of the video system's
modules, for example the integrated cameras. The codec and Touch controller behaves like in
regular standby. The video system wakes up from power save mode when you tap the touch
panel.
Waking up the video system from power save mode takes longer than waking it up from regular
standby, because the cameras must boot. You can make calls right away, but there is no outgo-
ing video until the cameras has completed their boot process.
Requires user role: ADMIN
Default value: Never
USAGE:
xConfiguration Standby PowerSave:
where
PowerSave
: Never/OutsideOfficeHours
Never: The video system will never go into power save mode; only to regular standby.
OutsideOfficeHours: The video system will go into power save mode during out-of-
office hours. You must provide the office hours with the following settings: Time
WorkWeek FirstDayOfWeek, Time WorkWeek LastDayOfWeek, Time WorkDay Start,
and Time WorkDay End.
92
API Reference Guide
xStatus Appendices
PowerSave
Copyright © 2017 Cisco Systems, Inc. All rights reserved.