Xconfiguration Conference Defaultcall Rate; Xconfiguration Conference Donotdisturb Defaulttimeout; Xconfiguration Conference Encryption Mode; Xconfiguration Conference Farendcontrol Mode - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Conference DefaultCall Rate

Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN, INTEGRATOR
Default value: 6000
USAGE:
xConfiguration Conference DefaultCall Rate:
where
Rate
: Integer (64..6000)
The default call rate (kbps).

xConfiguration Conference DoNotDisturb DefaultTimeout

This setting determines the default duration of a Do Not Disturb session, i.e. the period when
incoming calls are rejected and registered as missed calls. The session can be terminated
earlier by using the user interface. The default value is 60 minutes.
Requires user role: ADMIN, INTEGRATOR
Default value: 60
USAGE:
xConfiguration Conference DoNotDisturb DefaultTimeout:
where
DefaultTimeout
: Integer (1..1440)
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
Rate
DefaultTimeout
xCommand

xConfiguration Conference Encryption Mode

Define the conference encryption mode. A padlock with the text "Encryption On" or
"Encryption Off" displays on screen for a few seconds when the conference starts.
NOTE: If the Encryption Option Key is not installed on the video system, the encryption mode is
always Off.
Requires user role: ADMIN
Default value: BestEffort
USAGE:
xConfiguration Conference Encryption Mode:
where
Mode
: Off/On/BestEffort
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will
be encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted MultiSite conferences, all sites must
support encryption. If not, the conference will be unencrypted.

xConfiguration Conference FarEndControl Mode

Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Conference FarEndControl Mode:
where
Mode
: Off/On
Off: The far end is not allowed to select your video sources or to control your local
camera (pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local
camera (pan, tilt, zoom). You will still be able to control your camera and select your
video sources as normal.
58
API Reference Guide
xStatus Appendices
Mode
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.