Xconfiguration Network [1] Vlan Voice Mode; Xconfiguration Network [1] Vlan Voice Vlanid; Networkservices Configuration; Xconfiguration Networkservices Cdp Mode - Cisco MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Network [1] VLAN Voice Mode

Define the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you
have Cisco UCM (Cisco Unified Communications Manager) as provisioning infrastructure. Note
that Auto mode will NOT work if the NetworkServices CDP Mode setting is Off.
Requires user role: ADMIN, USER
Default value: Auto
USAGE:
xConfiguration Network n VLAN Voice Mode:
where
n
: Index that identifies the network. Range: 1..1
Mode
: Auto/Manual/Off
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN.
If CDP is not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If
CDP is available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.

xConfiguration Network [1] VLAN Voice VlanId

Define the VLAN voice ID. This setting will only take effect if Network VLAN Voice Mode is set
to Manual.
Requires user role: ADMIN, USER
Default value: 1
USAGE:
xConfiguration Network VLAN Voice VlanId:
n
where
n
: Index that identifies the network. Range: 1..1
VlanId
: Integer (1..4094)
Set the VLAN voice ID.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
Mode
VlanId
xCommand

NetworkServices configuration

xConfiguration NetworkServices CDP Mode

Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the
endpoint report certain statistics and device identifiers to a CDP-enabled switch. If CDP is
disabled, the Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration NetworkServices CDP Mode:
where
Mode
: Off/On
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.

xConfiguration NetworkServices H323 Mode

Define whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration NetworkServices H323 Mode:
where
Mode
: Off/On
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
74
API Reference Guide
xStatus Appendices
Mode
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.